1. Tap the Crestron Touch Panel to illuminate the screen, then turn on the iMac

2. Select the source. Doing so will power the system, including the projector, speakers, microphones, and project images from the selected source.
   • iMac = Select this input to project from the iMac
   • Lectern HDMI = Select this input to project an image from the connected device using the provided HDMI cable.
   • BluRay = Select this input to project the Blu-Ray Player

NOTE: When you select BluRay, a new window will appear with Blu-ray controls

3. To power off the system once you've finished using it, tap "All Off," located at the top right corner of the touch panel, then proceed by selecting "Yes" to confirm.

Troubleshooting

• If there is no audio coming out from the room speakers:
  • Refer to Forum Audio Setup
  • Press the Mute button, then press it again to unmute the speaker. This usually resets the audio.
• If the projector is not turning on:
  • Power off the System, let it stand for one minute, then power on
  • Check the projector for any errors. Refer to Forum Laser Projector Info
• If the problem persists, don't hesitate to contact Media Services at (310) 665-6972 or the Computer Lab at (310) 665- 6825 for assistance.